Changing Powerplay™ Touchpad Settings

How do I change my Jacuzzi® J-13 Powerplay™ touchpad settings out of Demo Mode?

Some Jacuzzi® J-13 Powerplay™ may need reprogramming for all pumps to work correctly.

Important note: All electrical work must be carried out by a licensed electrician. Any electrical information included here, whether it is troubleshooting or other instructions, are provided for use by a licensed electrician only. Local electrical codes supersede any information found here.

To resolve this issue, please follow the steps below. 
  1. Open the cover on the Balboa pack and put dipswitch #1 in the up/on position (test).
  2. Press the temperature UP button then the light button and then the temperature up button continuously to see the sequence S01, SO2, SO3, and stop at S04.
  3. Once S04 has been reached, press the light button to confirm this selection.
  4. Put the dipswitch #1 back to the down/off position and turn the power off, then on again.
  5. Check all pump operations.

    • Related Articles

    • How to enter Demo Mode on any SpaNet™ controller?

      The purpose of Demo mode on any SpaNet™ controller is to allow for the display and demonstration of the spa's features and touchpad functions in a safe and controlled manner without the need for water. This mode disables all the spa's relays, ...

    • How can I get my Fisher™ Spa or Vortex™ Spa out of Demo Mode?

      To exit demo mode on the Fisher™ Spa or Vortex™ Spa, you can follow these steps on any SV Series controller, including Mini controls: 1. Ensure that the spa is completely empty of water and that the heater tube is also empty of water. This will cause ...

    • Jacuzzi® J-13 Powerplay Installation Manual

      To view the Jacuzzi® J-13 Powerplay Installation Manual, please click the button below. Jacuzzi® J-13 Powerplay Installation Manual

    • SpaNet™ Smart Touch User Manual

      Click the button below to download the user manual for the SpaNet™ Smart Touch touch pad. Download SpaNet™ Smart Touch Manual How do I set up my SpaNet™

    • How to install a Jacuzzi® J-200™ Series drain valve

      Please follow instructions below for installing the J-200 drain valve. 1. Locate drain valve plug in cabinet panel and remove it. 2. Remove front cabinet panel (under touch pad) by unscrewing and removing the top rail and 1 x corner slat, cabinet ...